RPi Tutorials
rand_img_03_web.jpg

arduino_adaptor_build

The Arduino Adaptor requires you to solder just five components as follows:

R1 - 10K Resistor (Brown / Black / Orange)

R2 - 330R Resistor (Orange / Orange / Brown ) - not 150R as shown here.

J2 - 2x3 Pin Header

S1 - Tact switch

LED1 - 5mm Red LED

CONN1 - Not fitted ( this is only needed if for some reason you want to extend the reset switch ).

 

Here is a photo of the finsihed item, (J1 is already soldered for you, and R2 shows a 150R resistor but you should fit the 330R as described):

arduino adaptor v1 00 3

Follow eightdog8D on Twitter Follow eightdog8D on Twitter
Subscribe to our mailing list
Email Format
 

You can buy Laika from

 

Kitronik logo grey with green dots 250px wide

Technobots Logo V2

 Proto-pic 2012

 pimoroni-transparent

cpc logo 500px

ModMyPi

logo gross

ms logo 160px

 

Distribute the Laika range

Contact us if you are interested in distributing Laika.